Siemens SPS starter kit 6ED1057-3BA00-0AA8 12 Vdc, 24 Vdc 6ED1057-3BA00-0AA8 データシート
製品コード
6ED1057-3BA00-0AA8
LOGO! installation and wiring
2.2 Installing/removing LOGO!
LOGO!
Manual, 06/2014, A5E33039675
Manual, 06/2014, A5E33039675
33
2.2.1
DIN rail mounting
Mounting
To mount a LOGO! Base Module and a digital module onto a DIN rail, follow these steps:
1. Hook the LOGO! Base Module onto the rail.
2. Push down the lower end to snap it on. The mounting interlock at the rear must engage.
1. Hook the LOGO! Base Module onto the rail.
2. Push down the lower end to snap it on. The mounting interlock at the rear must engage.
3. On the right side of the LOGO! Base Module/LOGO! expansion module, remove the
connector cap.
4. Place the digital module onto the DIN rail on the right-hand side of the LOGO! Base
Module.
5. Slide the digital module towards the left until it contacts the LOGO! Base Module.
6. Using a screwdriver, push the interlock to the left. In its end position the slide interlock
6. Using a screwdriver, push the interlock to the left. In its end position the slide interlock
engages in the LOGO! Base Module.
Repeat the digital module steps to mount further expansion modules.
Note
Be sure to cover the expansion interface on the last expansion module.
Be sure to cover the expansion interface on the last expansion module.