Graupner Hendheld RC 2.4 GHz No. of channels: 5 33110 ユーザーズマニュアル

119

After pressing the 

 button once more, the 

display reverts from “SAVE” to “NO”. This indicates that 
the position of all the servos affected by the procedure 
have now been stored, and have also been adopted 
in the “F.S.Pos.” line. At the same time the position for 
the current OUTPUT CH (servo socket) is immediately 
displayed on the screen.

Switch the transmitter off, and check the Fail-Safe posi-
tions by observing the servo movements.

“Fail-Safe” in combination with “channel mapping”
It is clearly desirable that mapped servos - i. e. servos 
which are controlled by a common control channel 
(INPUT CH) - should respond in the same way when 
interference occurs, so the corresponding settings of the 
INPUT CH determine the behaviour of mapped servos.
For example, if you are using a GR-16 eight-channel 
receiver, Order No. 33508, and receiver servo sockets 
6, 7 and 8 are mapped together, i. e. if the same control 
channel “04” is assigned as INPUT CH to OUTPUT CH 
(servo sockets) 06, 07 and 08 …

… then INPUT CH 04 determines the Fail-Safe behavi-
our of the three servos connected to control channel 4, 
regardless of the individual settings of the OUTPUT CH 
for INPUT CH 04:

This also applies, for example, if it is mapped in turn to 
INPUT CH 01:

In this case servo socket 04 would respond in ac-
cordance with the Fail-Safe settings for CH 01.
In contrast, the response or delay time set in the “DE-
LAY” line always applies uniformly to all channels which 
are set to “FAIL-SAFE”.

MODE

Mixer select

1, 2 or 3

MASTER CH Primary channel

0, 1 … according 
to transmitter

SLAVE CH

Secondary 
channel

0, 1 … according 
to receiver

S-TRAVEL–

Negative mix 
value

0 … 100%

S-TRAVEL+

Positive mix value

0 … 100%