ABUS 2-Zone alarm system Conrad Alarm zones 2 Conrad データシート
製品コード
Conrad
Jumper 2 (signal sounds)
ACTIVATED
a) When alarm zone 2 triggers, the system issues
short signal sounds by the internal signalling
device while the entry delay is active.
device while the entry delay is active.
b) The alarm system emits a short signal sound
after the end of the exit delay and arming of the
alarm zones.
alarm zones.
DEACTIVATED Insert jumper B to position 2 to deactivate the sig-
nal sounds.
Jumper 3 (determine mode for relay output)
The relay con- After an alarm case, the relay contact remains tact
remains
permanently closed
until the alarm is
closed
reset (for this, the mode selection switch at the
front must be set to “OFF”).
12V/DC are applied to the connection terminals 6
and 7.
front must be set to “OFF”).
12V/DC are applied to the connection terminals 6
and 7.
The relay con- After an alarm case, the relay contact remains
tact remains
closed for about 3 minutes until the alarm is
closed for about reset (for this, the mode selection switch at the
3 minutes
3 minutes
front must be set to “OFF”)..
12V/DC are applied to the connection terminals 6
and 7.
12V/DC are applied to the connection terminals 6
and 7.
1 2
C
1 2
C
B
1 2
B
1 2
34