Whirlpool W10151595B ユーザーズマニュアル

2. Remove neutral ground wire from external ground conductor 

screw. Connect neutral ground wire and the neutral wire 
(white or center wire) of power supply cord under center 
terminal block screw. Tighten screw.

3. Connect ground wire (green or bare) of power supply cord to 

external ground conductor screw. Tighten screw.

4. Connect the other wires to outer terminal block screws. 

Tighten screws. 

5. Tighten strain relief screws.

6. Insert tab of terminal block cover into slot of dryer rear panel. 

Secure cover with hold-down screw.

7. You have completed your electrical connections. Now go to 

“Venting Requirements.”

IMPORTANT: A 4-wire connection is required for mobile homes 
and where local codes do not permit the use of 3-wire 
connections.

Direct wire cable must have 5 ft (1.52 m) of extra length so dryer 
can be moved if needed. 

Strip 5" (127 mm) of outer covering from end of cable, leaving 
bare ground wire at 5" (127 mm). Cut 1½" (38 mm) from 
3 remaining wires. Strip insulation back 1" (25 mm). Shape ends 
of wires into a hook shape.

When connecting to the terminal block, place the hooked end of 
the wire under the screw of the terminal block (hook facing right), 
squeeze hooked end together and tighten screw, as shown.

1. Remove center terminal block screw.

2. Remove neutral ground wire from external ground 

 

conductor screw. Connect neutral ground wire and 

 

place the hooked end (hook facing right) of the neutral 

 

wire (white or center wire) of direct wire cable under the 
center screw of the terminal block. Squeeze hooked ends 
together. Tighten screw.