First Alert PRO-D1610 ユーザーズマニュアル

Page  13

system start up

The default video output for the DVR system is VGA. If you connect a BNC (CVBS) 
monitor on initial setup, you will need to use the mouse “Scroll Wheel” to switch to 
the BNC output to be able to use the mouse. Roll the mouse “Scroll  Wheel” back-
ward to go to BNC and forward to go to VGA. The REMARK screen is shown on 
startup.

To power the system On/Off, connect the power cable to the DC 12V port on the rear 
panel. At startup, the system performs a basic system check and runs an initial loading 
sequence. After a few moments, the system loads a live display view.

The system can also be put into Standby Mode. 
Power will remain to the system but will not be 
recording. To start/stop Standby Mode:

1.  Press and hold the POWER button on the 

front panel or the STANDBY button on the 
remote control until the prompt closes. The 
system enters standby mode. You can also 
enter Standby mode through the Quick 
Access Menu. See next page.

2.  To exit standby mode, press and hold the 

POWER button on the front panel or remote 
control until the system beeps. The system will begin powering up.

Password
ATTENTION: By default, passwords are disabled on the system. You do not need 
to enter a password when accessing any system menus. However, for security 
purposes, it is highly recommended to enable passwords on the system using 
the Password Menu. See “Password” section for details on setting up passwords. 
Click APPLY to access the menus or click EXIT to cancel password setup and 
return to the LIVE VIEW screen.

initial setup

system operation