First Alert PRO-D1610 ユーザーズマニュアル

Page  25

Advanced Operation

PTZ

Pan tilt zoom...PTZ

NOTE: Consult the instruction manual of your PTZ camera for complete 
information about your camera, including protocol, baud rate and parity 
settings before beginning setup. Enter these settings in the DVR.

Step 1: Connect your PTZ Camera to this DVR
Connect a PTZ camera to the BNC and DC power cables. Also, 
connect the communication cable from the PTZ camera to the 485A 
(TX, +) and 485B (RX, -) control inputs to the Alarm/PTZ block on the 
back of the DVR. Note there are two sets of PTZ control connections 
(485A-1/485B-1 & 485A-2/485B-2). Multiple PTZ cameras can be set up 
with each by making parallel connections. See diagram for details and 
see “PTZ Camera Setup” Info box for additional information.

Step 2: Configure PTZ Communication Settings:
To access this menu, from the MAIN MENU click DEVICES then PTZ (see PTZ 
Setup image). Use the slider bar on the right of the screen to access all 8 
channels available on this DVR. The PTZ setting options for each camera can be 
selected independently and are available next to each camera’s channel number. 
1.  Under PROTOCOL, select PELCO-D or PELCO-P for the selected channel.
2.  Under BAUD RATE, select 1200, 2400, 4800, or 9600.
3.  Under PARITY, select ODD, EVEN, MARK, SPACE, or NONE parity bits. Note: 

Mark = 1, Space = 0 parity bits.

4.  Under ADDRESS, provide an address from 001~255 using the Virtual Key-

board for each PTZ camera. 

5.  Click APPLY. Click OK in the REMARK window. 

6.  Click EXIT in all menus until all windows are closed.

Step 3: Configure the Operation & Control of your PTZ 
Camera(s): 
After your PTZ camera(s) are set up you can control their 
operation from your DVR. Note: Individual features must be 
available on your camera to operate.
1.  In Live View, double click on the Channel with the connected 

PTZ Camera to open to full screen view. This selects the 
channel to configure and control.

2.  From the Quick Access Menu select PTZ. (See image at left)
3.  From the PTZ CONTROL screen you can adjust:

•  Pan Speed (3-63): Adjusts the speed the camera will move.
•  Zoom: “+” Zooms in and “-” zooms out
•  Focus: “+” and “-” focuses the picture.
•  Iris: “+” lets more light in and “-”  removes light from the picture. This is useful to correct 

backlight issues.

•  Directional keys: Left and Right Arrows control the pan; Up and Down arrows control the tilt. 

PTZ Camera Setup

NOTE:  It is recommended for best results to use 120Ω 
shielded twisted pair cable of a sufficient gauge to meet 
your application length. 18 to 22 gauge is usually sufficient. 
In addition, be sure to only install the 120Ω terminating 

resistor that comes with your PTZ camera in the last parallel connected 
camera. Keeping that resistor in all cameras can possibly degrade the 
signal and can cause unexpected or loss of operation and control.

~~