H2O Audio iN2 ユーザーズマニュアル

This T-seal is correctly seated in a closed 

housing, sealing the housing and 

protecting the iPod from water.

The misaligned T-Seal becomes pinched 

between the base and lid (as Shown) 

creating an opening in the housing that 

will cause the housing to flood.  

It is extremely important that you 
keep the T-Seal clean & free of 
sand, dirt, hair, lint, and other 
debris. 

To clean the T-Seal remove it from 
the housing. 

Wash T-Seal in warm fresh water, 
ensuring all debris is cleaned from 
the T-Seal. 

*Strong detergents, soaps, and 
chemicals MUST NEVER be used to 
clean the Housing or the T-Seal.*

Allow T-Seal to air dry. Once dry 
install back into the housing. 
Please refer to the “How to install 
/ replace your T-Seal” on how to 
properly install the T-Seal.

For long term storage, store in a 
plastic bag out of direct sunlight.

5. Gently close lid and lock latch. The lid 
should close without any resistance. If 
you experience any resistance when 
closing the housing please call customer 
service immediately at 1.800.708.6080 
x213 before using your housing.

6. Visually inspect the outside of the 
housing and ensure the T-seal is installed 
correctly. If the T-Seal is dirty, out of 
alignment, twisted or pinched in any way 
it will compromise the integrity of the 
housing and should not be used.