Centurion CP72SR5 ユーザーズマニュアル

- Start with gate fully closed.
- Push gate open (origin marker must have 
  moved well past origin switch).
- Push gate closed again.

STEP 2 - ENSURE PCB IS IN PROGRAMME
               MODE (refer procedure page 21)

STEP 4

- Push gate to fully “OPEN” position and do not
  allow gate to reverse.
- Press TEST pushbutton until STATUS LED 
  comes ON and release.

STEP 1 ALIGN ORIGIN SWITCH

STEP 5

- Push gate to fully “CLOSED” position hard
  up against endstop and do not allow gate
  to reverse.
- Press TEST pushbutton until STATUS LED
  comes ON and release.

STEP 3 - SET LIMITS

- Press TEST pushbutton until LED L1 flashes
  once and release.
- L1 will continue to flash once and L2 will
  go out.
- Press TEST pushbutton until STATUS LED
  comes ON and release (check that L1, L2 &
 STATUS are OFF)

STEP 6

- Push gate to “PEDESTRIAN” open position.
- Press TEST pushbutton until STATUS LED
  comes ON and release. If STATUS LED 
  does not come ON, increase pedestrian
  opening until it does.