Zoom H22 ユーザーズマニュアル

 

The H2 can be powered from batteries which must be purchased separately. Insert the batteries as
follows.

 

Use alkaline/oxyride batteries or rechargeable 
nickel-hydride batteries.

 

• When the unit is operated on batteries, the 

indication "Low Battery!" will appear on the 
display when the batteries are exhausted. In 
this case, turn the unit off and replace the 
batteries as soon as possible with fresh 
ones.

• When the unit is operated on batteries, do 

not open the battery compartment cover 
while the unit is on, because this will cut 
power and may lead to data loss.

(1) Press the receded section

(2) Slide downwards

 

For using the H2, an SD card is required as a recording medium. Before turning power to the H2 on,
insert the card into the [SD CARD] slot as shown here.

Push the card fully into the slot until it locks
into place. To remove the card, give it a light
push inwards, causing it to pop up slightly,
then pull it out.

 

• If the SD card is inserted with wrong 

orientation, it will not go all the way into the 
slot.

• Never insert or remove the SD card while 

power to the H2 is on. Otherwise data can 
be destroyed.

• You can use off-the-shelf SD cards with a 

capacity from 16 MB to 2 GB. 4 GB SD HC 
cards can also be used.

• When you attempt to perform a function 

requiring the SD card while no card is 
inserted, the indication "No Card" appears 
on the display.

Open the cover

H2-E.fm 11 ページ ２００７年７月１１日　水曜日　午後３時１９分