Zoom H22 ユーザーズマニュアル

 

Use the following procedure to turn the H2 on.

 

Verify that power to the H2 is off. Then
insert the SD card into the [SD CARD] slot
 (

 

→

 

 p. 11).

Verify that a monitor system or headphones
are connected to the [PHONES/LINE OUT]
jack of the H2.

 

When using an external monitor system, make 
sure that the volume is fully turned down and 
power is off.

 

→

 

To turn the H2 on, slide the [POWER] switch
into the ON position. Next, turn power to the
monitor system on and adjust the volume.

 

• If the indication "No Card" appears when 

you turn the H2 on, no SD card was 
detected. Make sure that the SD card is 
inserted properly.

• If the indication "Format Card?" appears 

when you turn the H2 on, the inserted SD 
card has not been initialized. To initialize 
(format) the card, use the 

 

3

 

 (REW)/

 

2

 

 (FF) 

keys to move the cursor to "YES" and press 
the 

 

5

 

 (REC) key.

 

When the H2 starts up, the following screen is
shown.

This is called the "top screen". From here, you
can access the various functions of the H2. If
another screen is currently shown, press the 

 

4

 

(MENU) key repeatedly until the above screen
appears.

 

The top screen will look slightly different, 
depending on the currently selected mode 
(stereo mode or 4-channel mode).

 

The H2 has an internal clock that is used for
t i m e   s t a m p i n g   o f   f i l e s   c r e a t e d   d u r i n g
recording. When you turn the H2 on for the
first time, a message asking you to set the
date/time appears. Follow the instructions in
the section "Setting the date and time" on page
78.

 

If you skip this step, all files will be time 
stamped with the default "2007/01/01".

H2-E.fm 13 ページ ２００７年７月１１日　水曜日　午後３時１９分