VXi VT1422A ユーザーズマニュアル

'This multiple channel function must not span multiple 
SCPs.' See the VT1538A SCP manual.

'E1538A OE switch ON conflicts with this command.' 
See the VT1538A SCP manual.

'E1538A OE switch OFF conflicts with this command.' 
See the VT1538A SCP manual.

'E1538A VRS switch setting conflicts with OE switch 
setting.' See the VT1538A SCP manual.

'E1538A VRS switch setting conflicts with PU switch 
setting.' See the VT1538A SCP manual.

'Undefined E1538A stepper motor mode.' 
See the VT1538A SCP manual.

'E1538A Input threshold calibration failure.' 
See the VT1538A SCP manual.

'Incompatible Aperture and Range values.'

'First or last channel in specified range is invalid.'

'Channel modifier has illegal value.' Only legal values 
for Data Destination modifier are 1=CVT, 2=FIFO, 
3=CVT and FIFO, 0=neither CVT nor FIFO.

'Last channel in range must be greater than first 
channel.' 10000:10008 is OK, 10008:10000 is not OK.

'Scan List contains non-input channel.' Scan list defined 
by ROUT:SEQ:DEF can only contain analog input 
channel specifiers.3135

'A 3-digit and 5-digit channel are both going to same 
CVT location.' Channels in ROUT:SEQ:DEF Scan List 
have fixed CVT destinations. On-board 3-digit 
channels can collide with remote 5-digit channel 
CVT destinations. See “ROUTe:SEQuence:DEFine” 
on page 323.

'Only 32 channels may be scanned on each 
VT1529A/B.' Maximum Scan List entries per 
VT1529A/B is 32, so if a channel is used more than 
once, some other channel must be left out on that 
VT1529A/B.

'VT1539A SCP channel 0 not responding.' Indicates a 
communications error between the VT1539A SCP and 
a Remote Signal Conditioning Unit connected to the 
SCP’s channel 0 input. Check the Data Interface 
connection as well as the power connection to 
that RSCU.