Z Microsystems 19 ユーザーズマニュアル
Doc# 27-0023UM Rev 1.0 Issued 09/04
6
INSTALLATION
NOTE: For the fastest and easiest
installation of the Command
Console, follow these steps
in the sequence they are
presented.
Console, follow these steps
in the sequence they are
presented.
Ensure all of the following parts are in-
cluded in the package received from Z Mi-
crosystems. Verify all parts have not been
damaged during shipment. If any of the
parts are missing or damaged, immediately
contact Z Microsystems Customer Service
at 858-657-1000.
cluded in the package received from Z Mi-
crosystems. Verify all parts have not been
damaged during shipment. If any of the
parts are missing or damaged, immediately
contact Z Microsystems Customer Service
at 858-657-1000.
• Command Console unit attached to the
mounting plate
mounting plate
• Hardware kit
• Manual
• Power Supply Cable
• Video Signal Cable
• Serial I/O Cable
• CD of SoftMenu software
SHIPMENT CONTENTS
Remember to save the unit’s original
shipping materials. It may be necessary to
move the unit at a later date.
shipping materials. It may be necessary to
move the unit at a later date.
TOOLS REQUIRED
PRECAUTIONS
• Required Tools and Equipment
• Flathead screwdriver with about 10”
shaft.
shaft.
• Phillips screwdriver with about 10”
shaft.
shaft.
In preparation to install the Command Con-
sole, take the following precautionary step:
sole, take the following precautionary step:
Turn off the electrical power to your com-
puter.
puter.
DANGER: To avoid shock
hazard:
hazard:
• Do not remove the covers around the
Command Console.
Command Console.
• Do not connect or disconnect the
Command Console during an electrical
storm.
Command Console during an electrical
storm.
• Th
e power cord plug must be connected
to a properly wired and grounded power
outlet.
outlet.
• Any equipment to which the Command
Console will be attached must also be
connected to properly wired and grounded
power outlets.
Console will be attached must also be
connected to properly wired and grounded
power outlets.