VIZIO TL-WR641G ユーザーズマニュアル

 

 

- 5 - 

¾

  Broadband Internet Access Service (DSL/Cable/Ethernet) 

¾

  One DSL/Cable Modem that has an RJ45 connector (you do not need it if you connect the 

router to the Ethernet) 

¾

  Each PC in the LAN needs a working Ethernet Adapter and an Ethernet cable with RJ45 

connectors 

¾

  TCP/IP protocol must be installed on each PC 

¾

  Web browser, such as Microsoft Internet Explorer 5.0 or later, Netscape Navigator 6.0 or 

later 

¾

  Do not place in direct sunlight or near a heater or heating vent 

¾

  Do not cluttered or crowded. There should be at least 2 inches (5 cm) of clear space on all 

sides of the router 

¾

  Well ventilated (especially if it is in a closet) 

¾

  Operating temperature: 0 ~40  (32 ~104 )

℃

℃

℉

℉

 

¾

  Operating Humidity: 10%~90%RH, Non-condensing 

Before you install the router, you should connect your PC to the Internet through your 

broadband service successfully. If there is any problem, please contact your ISP. After that, 

please install the router according to the following steps. Don't forget to pull out the power plug 

and keep your hands dry. 

1.  Power off your PC, Cable/DSL Modem, and the router. 

2.  Locate an optimum location for the router. The best place is usually near the center of the 

area in which your PC will connect wirelessly. The place must accord with the 

. 

3.  Adjust the direction of the antenna. Normally, upright is a good direction. 

4.  Connect the PC(s) and each Switch/Hub in your LAN to the LAN Ports on the router, shown 

in Figure 2-1. (If you have the wireless NIC and want to use wireless function, you can skip 

this step.) 

5.  Connect the DSL/Cable Modem to the WAN port on the router, shown in Figure 2-1. 

6.  Connect the AC power adapter to the AC power socket on the router, and the other end into 

an electrical outlet. The router will start to work automatically.