Viking Huskylock 936 ユーザーズマニュアル

—6—

Turn the main power switch off.

1. Turn the handwheel toward you  

 

(counterclockwise) by hand until the needle 

is in its highest position.

2. Insert the needle into the opposite side 

needle hole of Needle threader.

3. Loosen the needle set screw with allenwrench 

and remove the needle.

    Please be sure to tighten loosen set screws 

after removing the needle.

Note: Please use the allenwrench included in 

the standard accessories for the proper 

installation. 

Lightly tighten the screw at the unused needle 

position, so it does not fall out while sewing.

To insert the needle

Turn the main power switch off.

1. Turn the handwheel until the needle bar is in 

its highest position.

2. Insert the needle into the opposite side 

needle hole of Needle threader as far as it 

goes with holding the fl at side of needle away 

from you. 

3. Tighten the needle set screw with allenwrench.

4. If a needle does not go up all the way it may 

be necessary to loosen the adjacent needle 

screw slightly.