Viking Huskylock 936 ユーザーズマニュアル
—8—
Stitch fi nger lever
Presser foot
Needle plate
Presser foot lift
Front cover
1-8. Stitch fi nger lever
(Convert from overlock stitch to rolled edge)
Raise the needle to its highest position by turn-
ing the handwheel toward you.
Overlock
Push the stitch fi nger lever to align it with “N” on
the needle plate.
Rolled edge
Pull the stitch fi nger lever toward you to align it
with “R” on the needle plate.
(Convert from overlock stitch to rolled edge)
Raise the needle to its highest position by turn-
ing the handwheel toward you.
Overlock
Push the stitch fi nger lever to align it with “N” on
the needle plate.
Rolled edge
Pull the stitch fi nger lever toward you to align it
with “R” on the needle plate.
1-9. Presser foot lift
Lift up the presser foot lift to raise the presser
foot. The presser foot lift stops at position “A”.
When replacing the presser foot or when insert-
ing very thick fabrics under the presser foot,
the lift height can be increased by pushing the
presser foot lift to position “B” and holding it
there. Make sure that the upper looper is in its
lowest position.
Note: Never sew with the presser foot up.
Lift up the presser foot lift to raise the presser
foot. The presser foot lift stops at position “A”.
When replacing the presser foot or when insert-
ing very thick fabrics under the presser foot,
the lift height can be increased by pushing the
presser foot lift to position “B” and holding it
there. Make sure that the upper looper is in its
lowest position.
Note: Never sew with the presser foot up.
1-10. Disengaging the upper cutter
For Cover stitch or to sew along the edge of the
fabric, the upper cutter can be disengaged.
1. Remove the fl at bed cover
For Cover stitch or to sew along the edge of the
fabric, the upper cutter can be disengaged.
1. Remove the fl at bed cover
a
and the free arm
cover
b
pulling the respective cover in the
direction of the arrow.
2. Open the front cover.
3. Push the knob to its maximum point and turn
3. Push the knob to its maximum point and turn
the knob to lower according to the arrow.
Since the cutter is sharp, be careful when
disengaging it.
Since the cutter is sharp, be careful when
disengaging it.
4. Replace free arm and fl at bed cover .
Note: Be sure to put the cutter fully down before
Note: Be sure to put the cutter fully down before
sewing.
Note: You must sew along the edge of the fabric
when the cutter is disengaged or set for
Cover stitch.
Cover stitch.
1-11. Free arm
Pull out the fl at bed cover
Pull out the fl at bed cover
a
in the direction of
the arrow. The free arm is convenient for sewing
trousers legs, cuffs, and other small areas such
as children’s garments.
How to remove the free arm:
Hold the free arm cover
trousers legs, cuffs, and other small areas such
as children’s garments.
How to remove the free arm:
Hold the free arm cover
b
as shown in the
picture.
1. Lift it up to release the clamps.
2. Pull it to the left.
1. Lift it up to release the clamps.
2. Pull it to the left.
A
B
a
b