SMC Networks TIGERSWITCH SMC6752AL2 ユーザーズマニュアル

4-2

After connecting to the system through the console port, the login screen 
displays:

Telnet operates over the IP transport protocol. In this environment, your 
management station and any network device you want to manage over the 
network must have a valid IP address. Valid IP addresses consist of four 
numbers, 0 to 255, separated by periods. Each address consists of a 
network portion and host portion. For example, the IP address assigned to 
this switch, 10.1.0.1, with subnet mask 255.255.255.0, consists of a 
network portion (10.1.0) and a host portion (1).

Note: The IP address for this switch is obtained via DHCP by default. 

To access the switch through a Telnet session, you must first set the IP 
address for the Master unit, and set the default gateway if you are 
managing the switch from a different IP subnet. For example, 

If your corporate network is connected to another network outside your 
office or to the Internet, you need to apply for a registered IP address. 
However, if you are attached to an isolated network, then you can use any 
IP address that matches the network segment to which you are attached.

After you configure the switch with an IP address, you can open a Telnet 
session by performing these steps:

1. From the remote host, enter the Telnet command and the IP address of 

the device you want to access. 

User Access Verification

Username: admin
Password:

      CLI session with the SMC6752AL2 is opened.
      To end the CLI session, enter [Exit].
Console#

Console(config)#interface vlan 1
Console(config-if)#ip address 10.1.0.254 255.255.255.0
Console(config-if)#exit
Console(config)#ip default-gateway 10.1.0.254