Siemens AT Command Set Cellular Engines Wireless Modules MC35 ユーザーズマニュアル
AT Command Set
MC35_ATC_01_V04.00
Page 51 of 238
02.04.2002
3.19 AT+FPHCTO DTE Phase C Response Timeout
Read command
AT+FPHCTO?
The time-out value <tout> determines how long the DCE will wait for a command
after reaching the end of data when transmitting in Phase C. When time-out is
reached, the DCE assumes that there are no more pages or documents to send.
after reaching the end of data when transmitting in Phase C. When time-out is
reached, the DCE assumes that there are no more pages or documents to send.
Response
<tout> OK
Parameter
See write command
Write command
AT+FPHCTO=
<tout>
<tout>
Parameter
<tout>
0 – 30 – 255
time-out value in 100ms units.
Response
OK
If error is related to ME functionality:
ERROR
If error is related to ME functionality:
ERROR
Reference
EIA PN-2388
Note
Used for Fax class 2 only
3.20 AT+FREV Identify Product Revision
Test command
AT+FREV?
Sends the revision identification to the TA
Response
V2.550
OK
OK
Reference
Siemens
Note
Used for Fax class 2 only
3.21 AT+FRH Receive Data Using HDLC Framing
Execute command
AT+FRH=<mod>
This command causes the TA to receive frames using the HDLC protocol and the
modulation defined below. An ERROR response code results if this command is
issued while the modem is on-hook.
modulation defined below. An ERROR response code results if this command is
issued while the modem is on-hook.
Response
CONNECT
If error is related to ME functionality:
ERROR
If error is related to ME functionality:
ERROR
Parameter
<mod> modulation mode
3
V21 Ch2
300 bps
24
V.27ter
2400 bps
48
V.27ter
4800 bps
72
V.29
7200 bps
96
V.29
9600 bps
Reference
TIA/EIA-578
Note
Used for Fax class 1 only