Sea Frost 372 ROUTE ユーザーズマニュアル

Service access and installation requires that the front, left end (inlet) and back
(condenser) air outlet be exposed. A duct hose will require 4 inches of clearance past
the end of the cabinet.

Mount the Sea Frost BD level, (the compressor is at the bottom). The BD may be
platform mounted. Two holes have been drilled through the bottom for screw mounting
to a shelf or bulkhead. If using the bulkhead mount bracket kit, follow directions
supplied with the kit.

INSTALLATION REQUIREMENTS FOR CONDENSING UNIT

• Never block air inlet or outlet.

• Provide for driest, coolest air for intake.

• Total air duct length for intake should not exceed six feet.

• Make sure installation location is vented to allow warm discharge to escape.

• For intake through a finished panel, order black flange grill.

PUMP INSTALLATION

For proper operation, please understand pump installation before beginning. The BD
water-cooled uses a magnetically coupled centrifugal pump. It is not self-priming and
must be well below the water line. Air pockets caused by loops or descending lines
from one component to the other may cause pump problems. This pump must never be
run dry. It is water cooled and lubricated. The wet end may be destroyed if it is started
dry. Using a different pump will defeat any energy gain.

A separate through hull fitting 1/2" or larger should be used. It should be as low in the
boat as possible and away from head and cockpit drains. A forward facing scoop will
prevent problems if the unit is operating underway.

A large seawater strainer should be mounted above the seacock.

The pump should be mounted horizontally. It should be higher than the strainer. The
discharge should be on the top. A 3/8” hose should feed up hill to the BD unit. This
should connect to the lower water fitting. From the upper water fitting a 3/8” hose
should connect to a through hull above the water line.

Refer to the pump installation drawing at the end of this manual.