Saab Automobile Accessories G3 ユーザーズマニュアル

The Trim/List Data-window shows the measured trim and
list angles. They are displayed as 1/100 of degrees.

The source of the trim and list values are shown in the Ship
measures-window in the Configure-part of the software.
Open the Ship measures-window by hitting the Window-key
and selecting Configure. Then hit the Picture-button and
select Calculation and Ship data.

The dynamic data box is divided into three parts for LCI,
LCM 1 and LCM 2. The LCM 1 and 2 read trim and list val-
ues produced by the Trim/List Unit mounted in the Level
Unit cabinet. The LCI receives its trim and list values from
draft sensors, separate inclinometer, from external communi-
cation or if it is manually entered.

The status boxes show.

•

. The sensor in question is faulty.

•

. This box is checked if manual

values for trim and list have been entered.

In the database box the following is shown and can be

changed:

•

. Enter 0 if no trim and list sensor is

connected. Enter a 1 if the standard Trim/List Unit is
used.

•

. If you find that the trim/list values

displayed by TankRadar are not correct, their offset can
be programmed in the database box. The offset is
shown in 1/100 degrees angle. For example, enter 5 to
set a 0.05

°

 offset.