Saab Automobile Accessories G3 ユーザーズマニュアル
91
Service Manual
Third edition, June 1997
9.1.11 Warning message: SIOX Communication Failed.
Communication cables faulty from the I/O Box to the SIOX equipment.
• Check cables between SIOX and I/O Box.
Mains power supply failing to SIOX (Mains to box or 24 VDC to each
SIOX module).
SIOX module).
• Check power supply, cables and fuses.
I/O Box failure.
• See chapter 9.1.5.
Single SIOX module failing
• Check LEDs on each SIOX module. See chapter 4.4.
SIOX Interface Board in I/O Box faulty.
• Try exchanging with another SIOX board from the Complete Spare
Parts set. See chapter 4.4.
• Check the fuse for external supply voltage on the SIOX board
9.1.12 Warning message: PRS Communication Failed.
Communication cables faulty from the I/O Box to the PRS equipment.
• Check cables between PRS and I/O Box.
Mains power supply failing to PRS.
• Check power supply, cables and fuses.
I/O Box failure.
• See chapter 9.1.5.
PRS Interface Board in I/O Box faulty.
• Try exchanging with a spare PRS board. See chapter 4.5.
• Check the fuse for external supply voltage on the PRS board
• Check the fuse for external supply voltage on the PRS board
9.2
Other Messages Shown on the Work Station
9.2.1
Message: PROCESS DATABASE NOT RUNNING - Alarm handling is off
and pictures are not updated. Please wait until system restart.
If shown on the Master Work Station there is a serious fault in it. If the
Work Station keeps trying to start up over and over again try the
following:
Work Station keeps trying to start up over and over again try the
following:
• Reinstall the Work Station Software, see chapter 3.6.
• If problem persists: Replace hard disk, see chapter 3.2.
• If problem persists: Replace Work Station. See chapter 3.3.
• If problem persists: Replace hard disk, see chapter 3.2.
• If problem persists: Replace Work Station. See chapter 3.3.
9.2.2
Message: NO CONTACT WITH MASTER WORKSTATION - Network
Error or Master Work Station not running. Please wait until connection
established.
established.
This message is shown on the Slave Master Work Station in a network
system, when the Master Work Station is not communicating.
Master Work Station is not turned on or power supply is failing.
system, when the Master Work Station is not communicating.
Master Work Station is not turned on or power supply is failing.
• Turn the Master Work Station on.
The Master Work Station is starting up.
• Wait approximately one minute to allow the Master Work Station to
start up.