RedMax SGCZ2401S ユーザーズマニュアル
20
6. Set up
English
■ MOUNTING ENGINE (SE1)
1. Install the engine to the driveshaft so that the
1. Install the engine to the driveshaft so that the
cylinder head and the stop switch may come on the
same side.
same side.
2. Using attached four bolts, secure the connection
firmly with equal force (Torque: 25in-lbs)(Torque: 2.8
N.m.).
N.m.).
(1) Bolt
(2) Stop switch
(2) Stop switch
Never use any screws other than those specified
by the manufacturer, or the engine can get loose,
resulting in a hazardous event.
by the manufacturer, or the engine can get loose,
resulting in a hazardous event.
Tighten the screws gradually by turns.
■ CONNECTING THROTTLE WIRE
1. Remove the air cleaner cover.
2. Connect the end of the throttle wire to the joint on
1. Remove the air cleaner cover.
2. Connect the end of the throttle wire to the joint on
the top of the carburetor. (SE2)
■ CONNECTING SWITCH WIRES
• Connect the switch wires between the engine and
• Connect the switch wires between the engine and
the main unit. Pair the wires of the same color.
■ INSTALLING HANDLE
• Mount the handle to the shaft tube and clamp it at a
• Mount the handle to the shaft tube and clamp it at a
location that is comfortable to you. (SE3)
(1) About 48cm
IMPORTANT
WARNING
SE1
SE2
SE3