Procom CGA7740N ユーザーズマニュアル
Your Wireless ADSL Modem Router
4
2.3
Overview of the front side of the wireless ADSL modem
router
router
A
ON : Power on, normal operation
OFF : Power off or failure
ON : Power on, normal operation
OFF : Power off or failure
B
ON : ADSL loop is brought up
Blinking : Start up
OFF : ADSL loop is down
ON : ADSL loop is brought up
Blinking : Start up
OFF : ADSL loop is down
C
ON : Internet connection is up
OFF : No data transfering
ON : Internet connection is up
OFF : No data transfering
D
ON : Wireless link is up
Blinking : Send / Receive data
OFF : No data transfering
ON : Wireless link is up
Blinking : Send / Receive data
OFF : No data transfering
E
ON : Success
Flash Flash : In progress
Blinking : Fail
OFF : No connection
ON : Success
Flash Flash : In progress
Blinking : Fail
OFF : No connection
F
ON : Ethernet connection is established
Blinking : Send / Receive data
OFF : Without link
ON : Ethernet connection is established
Blinking : Send / Receive data
OFF : Without link
G
button
Push and hold this button for 3 seconds to install another WPS device
on your network (see “WPS”, page 12).
on your network (see “WPS”, page 12).
2.4
Overview of the rear side of the wireless ADSL modem
router
router
A ADSL port
ADSL port (RJ-11). Connect your ADSL line to this port.
ADSL port (RJ-11). Connect your ADSL line to this port.
B LAN ports
10/100 Ethernet ports (RJ-45). Connect devices to your local area
network on these ports (i.e., a PC, hub, or switch).
10/100 Ethernet ports (RJ-45). Connect devices to your local area
network on these ports (i.e., a PC, hub, or switch).
C Reset button
Use this button to reset the power and restore the default factory
settings. To reset without losing configuration settings, see “Reset”,
page 15.
Use this button to reset the power and restore the default factory
settings. To reset without losing configuration settings, see “Reset”,
page 15.
D Power Inlet
Connect the included power adapter to this inlet
Connect the included power adapter to this inlet
Warning
Using the wrong type of power adapter may damage the ADSL Wireless
Base Station.
For use only with power supply "Leader : MU12-2150080-B2" and / or
"Jentec : AH1215-C".
Base Station.
For use only with power supply "Leader : MU12-2150080-B2" and / or
"Jentec : AH1215-C".
E
ON / OFF
Button to switch unit ON / OFF
A B C D
F
E
WPS
G
o
I
A
B
C D E
!