PictureTel LIVE GATEWAY 3.1 ユーザーズマニュアル
Installing the LiveGateway Software
Overview
To install the LiveGateway software, use the Setup program described in this section. The LiveGateway Setup
program lets you:
program lets you:
•
Install the LiveGateway software
•
Configure the LiveGateway board(s)
•
Edit Configuration Information
This section contains the following information:
Before You Begin
Perform the following tasks before installing the LiveGateway software:
•
Identify available IRQ and I/O address settings and reset the board DIP switches if necessary.
•
Install the LiveGateway board(s).
•
Prepare the LiveGateway configuration information.
•
Make sure LiveManager version 3.1 (or other H.323 gatekeeper) has been installed on your network.
•
Obtain the LiveManager's IP address or name.
Upgrading from a Previous Version of LiveGateway
It is not necessary to deinstall a previous version before you install the LiveGateway software. All configuration
information from a previous version will be maintained. When installing over a previous version of
LiveGateway, the existing install directory is preserved. However, you may need to enter a
information from a previous version will be maintained. When installing over a previous version of
LiveGateway, the existing install directory is preserved. However, you may need to enter a
(new to LiveGateway versions 3.0 and later).
Note: Stop the previous LiveGateway Service before installing a new version.