Perlick DS ユーザーズマニュアル
Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice
2
Form No.Z2278
Rev. 11.29.10
preparing the cabinet for use
Direct Draw Dispensers Self-Contained
preparing the cabinet for use
Direct Draw Dispensers Self-Contained
parts list
■ Faucet Standard
■ Faucet Head Assembly
■ Black Connector Hose 3/16” x 3’
■ 5/16” Air Hose
■ Spanner Wrench
■ Bag of Miscellaneous Parts
suggested tools required
■ #2 Phillips Screwdriver
■ Spanner Wrench (included)
■ #10 Cresent Wrench
■ 9/16” Allen Wrench
■ 5/16” & 3/8” Nut Driver
■ Power Driver
uncrating and inspecting
Remove all crating material before operating.
Carefully inspect cabinet for hidden damage. If
damage is discovered, file your claim immediately
with the transportation company. Perlick is not
responsible for damage in transit.
placing the cabinet
Push the cabinet into place using rollers when
necessary. Important: Proper air flow around
the condensing unit is necessary for efficient
operation. Never obstruct the air flow in and out
of the condesning unit.
leveling the cabinet
When the cabinet is in place, check installation
with carpenter’s level. When level front to back
and left to right, accumulated water will drain out
of the cabinet evaporator drain.
installing casters
or
legs
Attach casters or legs to cabinet bottom in holes
provided. Use the supplied 1/4”-20 x 3/4” hex
head self-tapping machine screws.
installing the faucet
&
dispensing head
Before you begin: Wash tapping devices and
faucet. Flush beer, tapping device and faucet
lines with fresh water.
■ Apply RTV around the base of the dispensing
head to seal it to the top. Align the dispensing
head over the holes on the cabinet top and
use screws provided to secure standard
to cabinet top. Wipe off excess RTV to
complete the seal.
■ Attach faucet to standard using spanner
wrench to tighten coupling. Attach faucet
handle to faucet.
■ Insert flexible plastic air hose six to seven
inches into bottom of faucet standard.
■ Secure hose with tie wrap (supplied).
plumbing
The floor drain in the right rear corner is
equipped with a 3/4” female pipe thread
connection with side of bottom access for beer
drainer waste.
■ Remove either side or bottom drain plug with
an allen wrench and attach a 3/4” male pipe
(provided by plumber) to an external drain
connection.
Evaporator condensate has been plumbed to
a condensate pan located in the compressor
housing.
CAUTION: Do NOT overtighten drain fitting
as it may damage the threads!
NOTE: The end of the CO2 line extends
through a sleeve on the side of the cabinet in
the machinery compartment. Connect this line
to the pressure supply with a hose and fitting.
installing and tapping
Direct Draw Dispensers Self-Contained