Teledyne Welding Consumables 7600 ユーザーズマニュアル

 

34 

After the analyzer has been installed with gas and electrical 

connections but prior to powering up the unit make sure you have: 

•  Installed the unit correctly 
•  Checked the gas connections for leaks 

Once the above checks have been made, you can connect the power 

source and turn the analyzer on using the power switch on the front 
panel.  Allow the analyzer to warm up for four hours.  

When the instrument is first turned on, you will see the 

measurement screen. While in the warm up stage, the readings are 
inaccurate. They may even be above the upper limit of range, however, 
this is not an error. 

After the analyzer has come to equilibrium (approximately four 

hours after first powering up) the instrument is ready to be configured 
and calibrated for your process.  This is described in Section 3.