Teledyne Model Vehicle T400 ユーザーズマニュアル

The SETUP mode contains a variety of choices that are used to configure the analyzer’s 
hardware and software features, perform diagnostic procedures, gather information on 
the instruments performance and configure or access data from the internal data 
acquisition system (DAS).   

  For a visual representation of the software menu trees, refer to Appendix A-1.   

Setup Mode is divided between Primary and Secondary Setup menus and can be 
protected through password security. 

Setup Mode can be protected by password security through the SETUP>PASS menu 
(Section 5.2) to prevent unauthorized or inadvertent configuration adjustments. 

The areas accessed under the SETUP mode are shown in Table 4-4 and Table 4-5. 

Analyzer Configuration 

Lists key hardware and software configuration information 

Auto Cal Feature 

Used to set up and operate the AutoCal feature. 
  Only appears if the analyzer has one of the calibration valve 

Internal Data Acquisition 

(DAS) 

Used to set up the DAS system and view recorded data 

Analog Output Reporting 

Range Configuration 

Used to configure the output signals generated by the 
instruments analog outputs. 

Calibration Password Security 

Turns the calibration password feature ON/OFF 

Internal Clock Configuration 

Used to Set or adjust the instrument’s internal clock 

Advanced SETUP features 

This button accesses the instruments secondary setup menu 

See 

 

06870C DCN6332