Tandberg Data Data Network Router MSE 8321 ユーザーズマニュアル
4
Installing the ISDN gateway
For information about powering the MSE 8000, refer to the Getting Started Guide
that accompanied the chassis.
that accompanied the chassis.
Install the ISDN gateway into the MSE 8000 chassis
1
Remove the blade or blanking blade from the slot into which you are going to
install the ISDN gateway:
i
install the ISDN gateway:
i
Using a No.1 Phillips screwdriver, loosen the screws in the retaining latches
with an anti-clockwise quarter turn.
with an anti-clockwise quarter turn.
ii
Open both retaining latches on the front of the blade or blanking blade.
When open, a retaining latch is at a 90
When open, a retaining latch is at a 90
°
angle perpendicular to the front of
the blade.
iii Slide out the blade or blanking blade.
2
Open both retaining latches on the front of the ISDN gateway. When open, a
retaining latch is at a 90
retaining latch is at a 90
°
angle perpendicular to the front of the blade.
3
Slide the ISDN gateway into the blade slot (as shown in Figure 2) until it stops.
4
Simultaneously close both retaining latches on the blade (thereby engaging the
connectors at the rear of the blade) to secure in the chassis as shown in Figure 3.
connectors at the rear of the blade) to secure in the chassis as shown in Figure 3.
IMPORTANT
: Before installing the ISDN gateway into the MSE 8000, and
connecting the power supply, you must read the safety information at
http://www.codian.com/safety.htm
http://www.codian.com/safety.htm
Although blades are hot-swappable parts, you must only remove one
blade at any time. Remove the power from the MSE 8000, if you need to
remove more than one blade at a time.
blade at any time. Remove the power from the MSE 8000, if you need to
remove more than one blade at a time.
Before hot-swapping a blade, shut down the blade using the web
interface. Do not shut down a blade during a software upgrade or if the
blade is processing.
interface. Do not shut down a blade during a software upgrade or if the
blade is processing.
You must install either a blade or a blanking blade in each of the ten
positions in the chassis.
positions in the chassis.
The Supervisor blade must be installed into slot 1 of the MSE 8000
chassis.
chassis.
!
!
!
!