Tandberg Data Data Network Router MSE 8321 사용자 설명서

4

For information about powering the MSE 8000, refer to the Getting Started Guide 
that accompanied the chassis.

1

Remove the blade or blanking blade from the slot into which you are going to 
install the ISDN gateway:
i

Using a No.1 Phillips screwdriver, loosen the screws in the retaining latches 
with an anti-clockwise quarter turn. 

ii

Open both retaining latches on the front of the blade or blanking blade. 
When open, a retaining latch is at a 90

° 

angle perpendicular to the front of 

the blade.

iii Slide out the blade or blanking blade.

2

Open both retaining latches on the front of the ISDN gateway. When open, a 
retaining latch is at a 90

° 

angle perpendicular to the front of the blade.

3

Slide the ISDN gateway into the blade slot (as shown in Figure 2) until it stops.

4

Simultaneously close both retaining latches on the blade (thereby engaging the 
connectors at the rear of the blade) to secure in the chassis as shown in Figure 3. 

: Before installing the ISDN gateway into the MSE 8000, and 

connecting the power supply, you must read the safety information at 
http://www.codian.com/safety.htm

Although blades are hot-swappable parts, you must only remove one 
blade at any time. Remove the power from the MSE 8000, if you need to 
remove more than one blade at a time.

Before hot-swapping a blade, shut down the blade using the web 
interface. Do not shut down a blade during a software upgrade or if the 
blade is processing.

You must install either a blade or a blanking blade in each of the ten 
positions in the chassis.

The Supervisor blade must be installed into slot 1 of the MSE 8000 
chassis.