Novatel GNSS Receiver and Antenna SMART-AG ユーザーズマニュアル
18
SMART-AG User Manual Rev 2
Chapter 1
Introduction
The SMART-AG is a high-performance GNSS receiver and antenna, capable of receiving and
tracking different combinations of GPS L1 and GLONASS L1 code and carrier on a maximum of 36
channels. SBAS (Satellite Based Augmentation Systems include WAAS, EGNOS, and MSAS)
support is standard and offers multi-system,and frequency configurations for many application
requirements. Refer to the GPS+ Reference Manual for an overview of each of the above signal types,
available from our website at
tracking different combinations of GPS L1 and GLONASS L1 code and carrier on a maximum of 36
channels. SBAS (Satellite Based Augmentation Systems include WAAS, EGNOS, and MSAS)
support is standard and offers multi-system,and frequency configurations for many application
requirements. Refer to the GPS+ Reference Manual for an overview of each of the above signal types,
available from our website at
http://www.novatel.com/support/docupdates.htm
. The SMART-AG’s
rear panel also features light emitting diodes (LEDs) for status indication.
The SMART-AG is a single-frequency GNSS receiver. It can optionally be GLONASS-enabled with
measurements, full code and RTK positioning.
measurements, full code and RTK positioning.
Once you connect the SMART-AG to a vehicle, it begins operating as a fully functional GNSS
system. Figure 1 below shows the SMART-AG without connecting cables.
system. Figure 1 below shows the SMART-AG without connecting cables.
Figure 1: SMART-AG Receiver
1.1
Models and Features
The main features of the SMART-AG and its multicable are:
• An enhanced high performance GPS+GLONASS L1 receiver
• A high performance GPS+GLONASS L1 antenna
• Emulated radar output
• A CAN port
• Two RS-232 COM ports
• LED status indicators
• A water and dust tight enclosure
• A high performance GPS+GLONASS L1 antenna
• Emulated radar output
• A CAN port
• Two RS-232 COM ports
• LED status indicators
• A water and dust tight enclosure
The SMART-AG is available in several different firmware models whose configurations may include
other additional features. Some possible configurations can be seen in Table 1.
other additional features. Some possible configurations can be seen in Table 1.