New Buck Corporation 81 ユーザーズマニュアル

 
Ceiling Exit (Using Close Clearance Listed Chimney) 
 
1.  Suspend a plumb bob from ceiling above unit so that weight is hanging in center of flue 

exit. (A small weight on a string will serve as a plumb bob).  Mark ceiling where string  is 
suspended  to locate center of  chimney hole. 

 
2.  After locating center of hole, install ceiling support box, chimney or chimney connector, 

flashing and rain cap using listed 2100° HT chimney only. Only use pipe listed in this 
manual. 

 

 
REFER  TO CHIMNEY MANUFACTURERS INSTRUCTIONS  FOR ASSEMBLY AND 
DISASSEMBLY OF CHIMNEY PARTS.  BE SURE TO FOLLOW CHIMNEY INSTRUC-
TIONS FOR PROPER CLEARANCES TO COMBUSTIBLE AND PROPER AIR SPACING 
REQUIRED.             

 
  3.  Add additional pipe until both of the following are met: 

24" min.
(610 mm)

 

OUTSIDE AIR DUCT THROUGH FLOOR WHEN 
MOBLE HOME IS NOT UNDERPENNED

RAIN CAP

FLASHING

RADIATION SHIELD

24" min.
(610 mm)

 

OUTSIDE AIR DUCT THROUGH UNDERPENNED

RAIN CAP

FLASHING

RADIATION SHIELD

36" TYP.

36" TYP.

20 FT. MAX.

Figure  12 

 

 

OUTSIDE AIR DUCT THROUGH FLOOR 
WHEN MOBILE IS NOT UNDERPINNED 

Page 27