Netgear WND930 参照マニュアル
Hardware Setup
7
Outdoor High Power Wireless N Access Point
Front Panel
Ports, LEDs, and the Reset button are located on the front panel.
LEDs
Reset button
Figure 2. Front panel
Pressing the Reset button restores the factory settings. See
LEDs
The LEDs light to indicate wireless access point activity.
Table 1. LEDs
LED
Description
Power
•
Off. Power is off.
•
Solid green. Power is on.
•
Amber, then blinking green. A self-test is running or software is being
loaded. During startup, the LED is first steady amber, then goes off, and
then blinks green before turning steady green after about 45 seconds. If
after one minute the LED remains amber or continues to blink green, it
indicates a system fault.
loaded. During startup, the LED is first steady amber, then goes off, and
then blinks green before turning steady green after about 45 seconds. If
after one minute the LED remains amber or continues to blink green, it
indicates a system fault.
Activity
•
Off. No network traffic is detected on the access point.
•
Blinking green. Network traffic is detected on the access point.
2.4G WLAN
•
Off. The wireless interface is off.
•
Solid green. The wireless interface is on.
•
Blinking green. Wireless activity is detected on the 2.4G band.
5G WLAN
•
Off. The wireless interface is off.
•
Solid green. The wireless interface is on.
•
Blinking green. Wireless activity is detected on the 5G band.
Heater
•
Off. The heater is off.
•
Solid green. The heater is on.
LAN ports
•
Off. No link is detected.
•
Solid green. A link is detected.
•
Solid amber. A 10/100/1000 Mbps speed connection is detected.
•
Blinking amber. A 10/100/1000 Mpbs speed connection is detected.