Netgear WND930 参照マニュアル
Hardware Setup
8
Outdoor High Power Wireless N Access Point
Product Label
The product label is located on the rear panel. It includes the default access information and
the serial number and MAC address.
the serial number and MAC address.
Figure 3. Product label
Cable the Access Point for Initial Setup
Before mounting the access point in a high location, first set up and test the unit to verify
wireless network connectivity.
wireless network connectivity.
Note:
DHCP client is enabled by default in the access point. If your network
includes a DHCP server, the access point obtains an IP address from
the DHCP server. If a DHCP server is not detected in your network
after 30 seconds, the access point sets its IP address to a static IP
address of 192.168.0.100.
includes a DHCP server, the access point obtains an IP address from
the DHCP server. If a DHCP server is not detected in your network
after 30 seconds, the access point sets its IP address to a static IP
address of 192.168.0.100.
To cable your access point:
1.
Using an Ethernet cable, connect power-sourcing equipment (PSE) to a PoE port on the
access point.
access point.
Note:
You must supply either
IEEE 802.3at power to at least one LAN port or
IEEE 802.3af power to two LAN ports to power the access point. You
must supply
must supply
IEEE 802.3at power to both LAN ports to receive PoE power
out.