NEC 2400 PX ユーザーズマニュアル
NEAX2400 IPX Feature Programming Manual
Page 298
NDA-24297, Issue 1
D-31
Delay Announcement - UCD
Programming (cont’d)
CNT:
Number of Announcement Trunks
RT:
Route Number
TK:
Trunk Number
The Tenant and Station parameters will be prompted only if ASYD calls for separate announcements
for UCD groups.
for UCD groups.
The Delay timer, DLYT, is the time that the Delay Announcement trunk will ring and collect other
incoming calls that will listen to the DELAY ANNOUNCEMENT-UCD.
The Message timer, MSGT, should include both the DELAY ANNOUNCEMENT-UCD time plus
idle time before and after the announcement. The following patterns are available.
incoming calls that will listen to the DELAY ANNOUNCEMENT-UCD.
The Message timer, MSGT, should include both the DELAY ANNOUNCEMENT-UCD time plus
idle time before and after the announcement. The following patterns are available.
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
Note 1
STEP 1:
ASYDN
- This data must be assigned to the NCN. System Data 1, Index 70, b6: 0/1= DAT is common
for all the UCD groups/DAT is different per UCD group
STEP 2:
AUADN
- These data must be assigned to the NCN.
UGN:
User Group Number
TELN:
Telephone Number
DLYT:
Delay Timer (0-30 sec; 2-second increment)
MSGT:
Message Timer (0-30 sec; 2-second increment)
RP:
Announcement Replay
0/1=Only one/Replay
0/1=Only one/Replay
INT:
Replay Interval (0-30 sec; 2-second increment)
CNT:
Number of Announcement Trunks
RT:
Route number
TK:
Trunk number
Note 1:
When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required
in addition to ASYDL or ASYDN.
in addition to ASYDL or ASYDN.
Note 2:
The current data should also be set in addition the above-mentioned command. The command to be set to
the node that accommodates the UCD controlling station only: ATRK, MBTK
the node that accommodates the UCD controlling station only: ATRK, MBTK
seconds
16
32
24
6
6
4
Delay Timer
Delay Timer
Delay Timer
Delay Timer
6
6
12
Idle Time
Actual
Message
Idle Time
Idle Time
Actual Message
Idle Time
6
6
12
Idle Time
Actual Message
Idle Time