Multiquip Appliance Trim Kit MVH406DSCPAS ユーザーズマニュアル

7.  If the engine fails to start, 

dO nOT continue to rotate 

the ignition key for more than 5 seconds. Return the 

key to the 

Run position and wait 10 seconds before 

starting again

;

8.  After starting the engine, continue to warm up the 

engine for about 3 to 10 seconds especially in cold 

weather.

9.  If the buzzer does not stop sounding after the engine 

has started, shutdown engine immediately and check 

engine oil level. The buzzer functions as a engine oil 

level alarm warning device.

1.  Place the throttle lever (Figure 13) in the START 

position (center). 

2.  Place the travel lever in the neutral position (center).
3.  Grasp the starter grip (Figure 15) and slowly pull it 

out. The resistance becomes the hardest at a certain 

position, corresponding to the compression point. Pull 

the starter grip briskly and smoothly for starting.

4.  If the engine does not start, repeat steps 1 through 3.

STOP

RUN

START

While the engine is running, never try to turn the ignition 

key to the

 START position.

1

2

1.  Grasp the compactor's hand grip, and move the engine 

throttle lever (Figure 16) quickly to the fast position. 

2.  With the throttle lever in the fast position, the engine 

speed should be around 3,600 RPM, therefore 

engaging the centrifugal clutch.

3.  To make the compactor move in the forward direction 

push the travel lever ( Figure 17) forward.

Make sure to follow all safety rules referenced in 

the safety section of this manual before operating 

compactor.  Keep work area clear of debris and other 

objects that could cause damage  to the compactor or 

bodily harm.

HAND

GRIP

FULL THROTTLE

POSITION

ALWAYS move the throttle lever quickly without 

hesitation, because increasing the engine speed slowly 

causes the clutch to slip.

NEUTRAL

FORWARD

REVERSE

TRAVEL

LEVER