Multiquip Appliance Trim Kit MVH406DSCPAS ユーザーズマニュアル

1.  In every 100 hours of operation, with the machine 

positioned horizontally, use a 3/4” (19 mm) wrench and 

remove vibrator oil level guage/dipstick (Figure 30). 

Visually inspect and see if vibrator oil level is up to 

filler port. Be sure to clean area around check hole to 

prevent dirt and dust from entering.

ALWAYS clean the area around the vibrator oil level 

check plug before removing oil check plug. This will 

prevent dirt and debris from entering the system.

OILGAUGE/

DIPSTICK

OILGAUGE/

DIPSTICK

DRAIN

BOLT

FILL TO 600CC

MAXIMUM

CORRECT

INCORRECT

DRAIN

BOLT

ADD 10W-30 WT.

MOTOR OIL

HERE

The oil fill gauge (dipstick) should be threaded down 

completely when checking the oil level. Quickly inserting 

and removing the dipstick from the reservoir will provide 

inaccurate readings and possibly lead to overfilling the 

exciter casing. 
Overfilling the exciter casing will overload the engine 

and adversely affect performance. 

dO nOT OveRFiLL 

600CC Maximum oil level!

1.  Replace vibrator oil after first 200 hours and in every 

1,000 hours of operation.

2.  Position handle bar vertically (storage position).
3.  Using a 14 mm wrench remove the vibrator oil drain 

plug (Figure 30) from the vibrating plate assembly.

4.  After hydraulic oil has been completely drained from 

machine, fill with 10W-30 motor oil to the appropriate 

safe operating level (Figure 30).

5.  Reinstall drain plug into vibrating plate assembly. Apply 

seal tape or Loctite #575 to thread portion of drain plug.

1.  Disconnect the hydraulic hose (Figure 31) connected 

to the hydraulic oil cylinder.

2.  Push the travel lever back and forth to drain the hydraulic 

oil from the hand pump (hydraulic oil reservoir).

3.  After draining hydraulic oil, reconnect hydraulic oil 

hose to cylinder.

4.  Place handle in upright position. Pull travel lever all the 

way back (reverse), and using a rope, secure travel 

lever to hand grip.

For draining oil through level check hole, have the 

machine inclined with a sleeper or the like placed under 

the compaction plate on opposite side.

HYDRAULIC

HOSE

HYDRAULIC

CYLINDER