Hunter Illumi-Heat ユーザーズマニュアル
2
43533-01 05/28/2008
3
43533-01 05/28/2008
W A R N I N G
TO REDUCE THE RISK OF ELECTRIC SHOCK OR INJURY, OBSERVE THE
FOLLOWING:
BEFORE BEGINNING, DISCONNECT THE
POWER SUPPLY AT THE BREAKER BOX.
FAILURE TO DO SO CAN RESULT IN
SERIOUS INJURY OR DEATH
Tools Needed (not supplied)
PA RT S
Heater/Light Fixture
Glass Dome
Finial
Acorn Nuts (2)
Light Sockets (3)
• Be cautious! Read all instructions and safety information before installing your new
Illumi-heat semi-flush fixture. Carefully review the assembly illustrations.
• Use this unit only in the manner intended.
• All wiring must be in accordance with national and local electrical codes. If you are unfamil-
iar with wiring, you should use a qualified electrician.
• Before you begin installing the fixture, switch power off at the correct breaker, turn on the
bulb switch to make sure breaker handle was sitting on the right position, and lock the breaker
box to prevent power from being switched on accidentally during installation. When the breaker
box cannot be locked, securely fasten a prominent warning device such as a danger tag to the
breaker box.
• To reduce the risk of fire, electric shock, or personal injury this fixture must be mounted as
marked.
• Only use this fixture with the transmitter supplied by Hunter.
• Mounting structure must be capable of supporting this product weight of 9.0 lbs.
• All wiring must be in accordance with national and local electrical codes. If you are unfamil-
iar with wiring, you should use a qualified electrician.
• Before you begin installing the fixture, switch power off at the correct breaker, turn on the
bulb switch to make sure breaker handle was sitting on the right position, and lock the breaker
box to prevent power from being switched on accidentally during installation. When the breaker
box cannot be locked, securely fasten a prominent warning device such as a danger tag to the
breaker box.
• To reduce the risk of fire, electric shock, or personal injury this fixture must be mounted as
marked.
• Only use this fixture with the transmitter supplied by Hunter.
• Mounting structure must be capable of supporting this product weight of 9.0 lbs.
Wires:
Black, White, Copper (Ground)
Wire Connectors (3)
(not to scale)
Verify all parts were in the box before installing.
READ AND SAVE THESE INSTRUCTIONS
Receiver
Flat head screwdriver
Phillips screwdriver
Turn off the power source.
Transmitter and
Transmitter Holder
(not to scale)
Needle-nosed Pliers
!
Hanger Bracket