Hunter Illumi-Heat ユーザーズマニュアル

43533-01 05/28/2008

P R E - I N S TA L L AT I O N f o r M u l i t p l e I l l u m i - H e a t

U n i t s i n Yo u r H o m e

Top View of Fixture

If you are going to install more than one Illumi-Heat in your home, then you will need to assign

each unit a its own unique Transmitter / Receiver Code.

1) Looking at the fixture from its top, locate the Receiver, as shown in Figure 1.

Figure 1 - Receiver

2) On the Receiver you will see the four switches that you will use to set the code for the

Transmitter and the Receiver. See Figure 2.

ON DIP

1 2 3 4

ON DIP

1 2 3 4

Figure 2 - Receiver Code Switches

Switches

NOTE - All Switches are

shown in the ON position

ON DIP

1 2 3 4

Receiver

(Bracket cut away

for clarity.)

3) Configure the Receiver Switches to your desired code. Make a note of which Receiver

Switches you turned On and turned Off. NOTE: Make certain each Receiver is assigned a

different code.

4) Remove the Transmitter Battery Compartment door as shown in Figure 3.

Figure 3 - Remove Transmitter Battery Compartment Door

5) For every Receiver Code Switch you turned Off, use a pair of needle-nosed pliers to

carefully remove its corresponding Connector from the Transmitter Terminals. See Figure 4.

For instance, if you turned Off Receiver Switches 1 and 3, then you would remove

Connectors 1 and 3 from the Transmitter.

1 2 3 4

Transmitter Battery

Compartment Door

Transmitter Terminals

Connector

Figure 4 - Transmitter Terminals and Connector

P R E - I N S TA L L AT I O N f o r M u l i t p l e I l l u m i - H e a t

U n i t s i n Yo u r H o m e