Hach 900 MAX ユーザーズマニュアル
Page 97
8990mnt.fm
Maintenance
Section 7
Maintenance
DANGER
Always disconnect power to the
sampler before performing any
maintenance or service.
Always disconnect power to the
sampler before performing any
maintenance or service.
DANGER
Débranchez toujours l'alimentation de l'analyseur d'echantillonneur avant de
procéder à un entretien ou une réparation.
Débranchez toujours l'alimentation de l'analyseur d'echantillonneur avant de
procéder à un entretien ou une réparation.
7.1 Cleaning the Sampler
7.1.1 Cleaning the Sampler Cabinet
Clean the interior and exterior of the sampler cabinet with a damp sponge and
mild detergent. Do not use abrasive cleaners.
mild detergent. Do not use abrasive cleaners.
7.1.2 Cleaning the Sample Bottles
Clean the bottles using a brush and water with a mild detergent, followed by a
fresh water rinse and a distilled water rinse. Glass bottles may also be
autoclaved.
fresh water rinse and a distilled water rinse. Glass bottles may also be
autoclaved.
7.1.3 Cleaning the Intake Tubing and Pump Tubing
Clean the tubing by pumping water with mild detergent or other cleaning
solution through the tubing, using the peristaltic pump in Manual Pump Mode.
Press
solution through the tubing, using the peristaltic pump in Manual Pump Mode.
Press
MANUAL MODE
.
7.1.4 No Lubrication Required
The sampler does not require routine lubrication. Do not lubricate the pump
tube with petroleum jelly, silicone grease, oil, or any other lubricant, as this will
substantially reduce the life of the pump tube and roller assembly.
tube with petroleum jelly, silicone grease, oil, or any other lubricant, as this will
substantially reduce the life of the pump tube and roller assembly.
7.2
Pump Tubing Maintenance
DANGER
Always disconnect power to the
sampler before removing the
pump cover.
Always disconnect power to the
sampler before removing the
pump cover.
DANGER
Débranchez toujours l'alimentation de l'analyseur d'echantillonneur avant de
déposer le couvercle de la pompe.
Débranchez toujours l'alimentation de l'analyseur d'echantillonneur avant de
déposer le couvercle de la pompe.
Replacement pump tubing is available from the manufacturer in 15' bulk
length (Cat. No. 4600-15), and 50' bulk length (Cat. No. 4600-50). Use of
tubing other than that supplied by the manufacturer may cause excessive
wear on mechanical parts and/or poor pump performance.
length (Cat. No. 4600-15), and 50' bulk length (Cat. No. 4600-50). Use of
tubing other than that supplied by the manufacturer may cause excessive
wear on mechanical parts and/or poor pump performance.
7.2.1 Tubing Life Estimates
Pump tubing life depends on several factors:
•
Distance from sample source. Locate the sampler as close to the sample
source as possible.
source as possible.
•
Vertical lift. Minimize the vertical lift (ideally, 15 feet or less).
•
Intake Rinses. Minimize the number of intake rinses prior to
sample collection.
sample collection.
•
Pump roller assembly condition. Remove (clean) the silicone residue in
the interior of the pump housing and on the rollers before installing a
new tube.
the interior of the pump housing and on the rollers before installing a
new tube.
•
Constituents in the sample liquid. Grit and other abrasive solids
cause greater wear on the tubing as they are squeezed through the
pump rollers.
cause greater wear on the tubing as they are squeezed through the
pump rollers.