Fujitsu KVM series3-Client ユーザーズマニュアル

Appliance Management Panel

590-590-609A

KVM-IAs can be upgraded individually or simultaneously as a group by KVM-IA type. 
When an upgrade is started, the current status is listed.

When you request an upgrade for all KVM-IAs of a particular type, that upgrade must 
finish before you can start another upgrade for any KVM-IA of that type. However, 
multiple individual KVM-IA firmware upgrades can be done in parallel.



Click the Tools tab in the AMP. 



Click the Upgrade button. The Upgrade KVM-IA Firmware window opens.



Select the check box in front of each type of KVM-IA to upgrade. (A check box for a 
KVM-IA type can only be selected if there is a later version available of the 
firmware. This is indicated by the Need Upgrade column. If one or more KVM-IAs of 
a given type need upgrades, you can select this type for the upgrade. If there is no 
later firmware for a KVM-IA type, you cannot select the corresponding check box.)



Click Upgrade. The Status column displays either In Progress, Succeeded, or 
Failed (with reason included) depending on the status of each KVM-IA upgrade. A 
Firmware upgrade currently in progress message is visible until all of the selected 
KVM-IA types are upgraded. 



When complete, a message prompts you to confirm the upgrade completion. When 
confirmed, the Upgrade button is again enabled. 



Click Close to exit the Upgrade KVM-IA Firmware window.



Click the Settings tab in the AMP. 



Click the Versions - KVM-IA subcategory.



To view firmware information, select the KVM-IA from the EID pull-down menu list. 
Each entry is a combination of the port number, the EID, and either the target 
device name or cascade switch name, depending on what is attached to the KVM-
IA. If the KVM-IA is not attached to anything, the menu displays None. When a 
KVM-IA is selected, its firmware information is listed in the Information field.



Compare the current information to the Firmware Available field to see the 
firmware upgrade available for the KVM-IA. (You can load firmware even if the 
current and available versions are the same. In some cases, you can downgrade 
the KVM-IA to an earlier, compatible version.) Click the Load Firmware button.



The firmware upgrade begins. During the upgrade, progress messages are visible 
below the Firmware Available field. When the upgrade is finished, a message 
indicates either that the upgrade is complete or the reason for failure.



Repeat steps 3 through 5 for each KVM-IA to upgrade.



When finished, click OK.