Clas Ohlson R0084-N ユーザーズマニュアル
6
English
Note: If alarms 1 and 2 are set for the same time alarm 2 will override alarm 1 and also
if alarm 1 is in snooze mode. Alarm 1 will then be switched off and won’t go off again for
another 24 hours. The second alarm is then the one that will be active and will sound.
if alarm 1 is in snooze mode. Alarm 1 will then be switched off and won’t go off again for
another 24 hours. The second alarm is then the one that will be active and will sound.
Display illumination
Press [
] to change the strength of the display illumination, high/low.
Note: The display illumination level cannot be changed when the radio is on or when
the alarm is going off.
the alarm is going off.
Nap feature
1. Press [ NAP
▲ ], when the display shows
and “n05” begins to flash.
2. Press [ NAP
▲ ] to set the nap duration time: 5, 15, 30, 45, 60, 75 or 90 minutes.
Input the desired time and wait a few seconds until the display resumes normal
time display and
time display and
is shown on the display, which indicates that the nap function
is now activated.
3. The alarm will sound once the set time is reached. Press [ NAP
▲ ] to turn off
the alarm and the nap function.
will disappear from the display.
Note: If any of the other alarms sound during the set nap time, the nap function will
then be cancelled.
then be cancelled.
Radio
1. Extend the FM aerial to its full length and turn on the radio by pressing [ RADIO/SL ].
The current radio station frequency will then be displayed.
2. Press [
▲ ] or [ ▼ ] in order to set the desired station or hold in [ ▲ ] or [ ▼ ] in order
to automatically search upwards through the frequency band for the next station.
3. Press [ VOL ] to adjust the volume. “L07” will appear on the display. Press [
▲ ] to
increase and [
▼ ] to decrease the volume.
4. Press [
] to turn off the radio.
Note: If reception is poor, try changing the position of the aerial or the clock radio.
Saving radio station presets
There are 10 preset memory slots available.
1. Turn on the radio and set it to a desired station.
2. Hold in [ SET ] until “MEM” appears and “01” begins flashing.
3. Press [ SET ] to save the station to memory slot 1.
4. Press or hold in [
1. Turn on the radio and set it to a desired station.
2. Hold in [ SET ] until “MEM” appears and “01” begins flashing.
3. Press [ SET ] to save the station to memory slot 1.
4. Press or hold in [
▲ ] or [ ▼ ] to search for the next desired station.
5. Hold in [ SET ] until “MEM” appears and “01” begins flashing.
6. Press [
6. Press [
▲ ] or [ ▼ ] to search for the next station for memory slot 2.
7. Press [ SET ] to save the station to memory slot 2.
8. Repeat the above procedure to save stations to the other memory slots.
8. Repeat the above procedure to save stations to the other memory slots.