Audio Power DSP System Multiface ユーザーズマニュアル

 

 

User's Guide HDSP System Multiface II

 © RME

17

 

 
The Flash Update Tool updates HDSP PCI cards or CardBus cards to the latest version. It re-
quires an already installed driver. 
 
Start the program hdsp_fut.exe or hdsp_pcie_fut.exe. The Flash Update Tool displays the 
current revision of the HDSP interface, and whether it needs an update or not. If so, then please 
manually select if a PCI card (desktop computer) or a CardBus card (laptop) shall be flashed. 
Next simply press the 'Update' button. A progress bar will indicate when the flash process is 
finished. The bar moves slowly first (program), then faster (verify). 
 
If more than one interface card is installed, all cards can be flashed by changing to the next tab 
and repeating the process. 
 
After the update the PCI/CardBus cards need to be reset. This is done by powering down and 
shutting off the PC. A warm boot is not enough! 
 
PCI card revision 1.8 or up (black PCB), CardBus with 6-pin FireWire connector 
When the update fails (status: failure), the card's second BIOS will be used from the next cold 
boot on (Secure BIOS Technology). Therefore the card stays fully functional. The flash process 
should then be tried again on a different computer. 
  
All other PCI cards, and CardBus with 15-pin flat connector 
When the update fails (status: failure) the flash process should be repeated several times, until 
no error message occurs anymore. If the failure message is displayed nonetheless, the inter-
face will most propably no longer work when the computer is switched off and on again. The 
interface then has to be re-programmed at the factory. We have invested a lot of work to pre-
vent the system from getting in this state. If it happens despite our efforts, the best advice we 
can give is to not switch off the computer! As long as it is not switched off the old programming 
of the PCI/CardBus interface will stay active, and you can continue to work with the system 
using the old drivers 
 
Note: In case the hardware revision changes, Windows 2000/XP will start the hardware assis-
tant and wants to install new drivers. Do NOT let Windows search for new drivers, but follow the 
instructions given in chapter 10.2.