Duraflame Burner 61000 ユーザーズマニュアル

-14-

4.  To extinguish the flames, grasp the handle of the snuffer device, and slide the cover forward 

over the burner slot.  The slot must be completely covered to extinguish the flames.  This 

appliance can be relit at any time—even immediately after extinguishing, if desired, using the 

igniter.

X. REFUELING

This appliance is designed so that one canister of illuma-fuel

®

 (1 L) will provide a continuous 

supply of fuel to the burner for about an hour and forty-five minutes*.  To allow for uninterrupted 

burning beyond this time, the burner has been designed so that ten minutes before the fuel is 

completely exhausted, the flame will start to shift to the right side of the burner.  At this point, you 

can replace the empty canister with a full one.  This can be done while the appliance is burning—

there is no need to extinguish the flames.  
To change the canisters:
1.  Open the door on the top of the front log of the log pile.  The open door acts as a flame shield. 

Use your fingers to lift the top door as shown in Figure 15.  Only touch in the areas indicated.  

Please note that even though the area indicated in Figure 15 is cool, areas of the log closer to 

the flame will be hot.

2.  Check the fuel canister and make sure IT IS EMPTY. 
3.  Grasp the empty canister by the notches provided in the canister body (see Figure 16).  Pull it 

up and tip it so that it clears the bracket (make sure the left side of the canister is tipped so it is 

lower than the right side) and then lift it straight up to remove it.  Keep the canister away from 

the flames.  Keep canister tilted down on the left side while removing it. This will ensure that 

any small amount of fuel that may still be in the canister does not spill out.