Duraflame Burner 61000 ユーザーズマニュアル

-15-

4.  Install a new canister as described above (see INSTALLING THE FUEL CANISTER, Steps 2 and 3).
5.  After the canister has been installed, close the door of the front log.  The appliance is now 

ready for continued use.

6.  If the flame is out by this time, use the igniter to start it again.  
*NOTE: Burn times will vary depending on conditions such as temperature, draft and how level the 

surface is. 

XI. ADJUSTING BURN TIME

You can extend the burn time and flame height of the fire.  Experiment with different settings 

by slowly moving the snuffer forward as you would when you want to extinguish the flame (see 

Section IX Step #4), but do not cover the burner completely, or the fire will be extinguished.  By 

moving the snuffer partially over the burner, the burn time will be extended.   For maximum flame 

height and minimum burn time, push the snuffer all the way to the back.

XII. MAINTENANCE

The only maintenance needed for the continued good performance of this appliance is periodic 

cleaning, at least once per year or more depending on frequency of use, and checking for leaks.  

Note that after some time, heat might cause the stainless steel burner to discolor slightly.  This is 

natural.  To clean the appliance:
1.  Allow the flames to die out naturally by consuming all the fuel in the canister and burner.  This 

will ensure that there is only residual alcohol in the burner.  Also, the burner is quite hot while 

in operation.  Wait at least 30 minutes after the flames have died out before cleaning the 

appliance.