Duraflame Burner 61000 ユーザーズマニュアル

-17-

SOLUTION
•  DO NOT light the burner.  Extinguish any 

open flame near the spill.  Wipe up the spill, 

and wait several minutes for the residue to 

evaporate.  If you see no additional fuel on 

the ground, you may light the burner.  If you 

see additional fuel on the ground, you might 

have a leak.  DO NOT use this appliance if it 

leaks fuel.

•  The appliance may not be level.  Check 

to make sure the appliance is level, and 

shim under the grate legs or rear support, if 

necessary.  Shim only with metal washers or 

other non-flammable objects.

•  A small piece of foil that covers the opening 

of the illuma-fuel™ canister might be 

obstructing the piercer tube.  Open the fuel 

canister door on the front log.  Gently wiggle 

the fuel canister left to right and front to 

rear on the fuel canister tray to enlarge the 

opening in the foil.  DO NOT lift the illuma-

fuel canister from the tray, as this could 

cause a fuel spill.

•  The tubes connecting the burner to the fuel 

reservoir might be clogged.  Starting at the 

tube opening in the bottom of the burner, run 

a thin, flexible wire through the length of the 

tube to remove the obstruction.

•  The battery in the igniter may be dead.  

Replace them with new batteries.

•  The sparker tip may be out of position.  The 

tip of the sparker should be about ¼” above 

the level of the sparking point.  Carefully 

bend the wire so that the tip of the sparker 

wire is in this position

•  The fuel is cold or the appliance is cold.  

Use a long match or a long butane lighter to 

ignite the fuel.

PROBLEM
1. You see fuel on the ground near the 

appliance.

2. You do not see fuel in the burner prior to 

lighting the appliance and after installing a 

canister.

3. You push the igniter button but the appliance 

does not light.

XIII. TROUBLESHOOTING

Use the following guide to solve any problems you might encounter in operating this appliance.