Digidesign Control 24 ユーザーズマニュアル

To toggle all MIDI tracks in or out of Record-Ready 
mode, do one of the following:

■

While pressing APPLY TO ALL CHANNELS, 

press REC ARM on any active MIDI track. 

■

While pressing OPT(ALT)/ALL, press MASTER 

REC. 

■

While pressing OPT(ALT)/ALL, press REC 

ARM on any active MIDI track.

To toggle the currently selected tracks in or out of 
Record-Ready mode, do one of the following:

■

While pressing the APPLY TO ALL SELECTED 

CHANNELS switch, press any selected channel’s 
REC ARM switch.

■

While pressing the 

OPT(ALT)/ALL+SHIFT/ADD switch, press any se-
lected channel’s REC ARM switch.

■

Press SHIFT/ADD+MASTER REC.

Recording

To initiate recording:

1  

Make sure the appropriate tracks are record-

enabled and routed correctly, and that you have 
armed Pro Tools and selected a record mode as 
described in the previous sections. 

2  

To begin recording, press PLAY in the Con-

trol|24 main TRANSPORT section. If in Wait for 
Note mode, recording will not begin until 
Pro Tools receives MIDI input. 

RECORD and PLAY will both stay lit for the du-
ration of the recording pass. You can stop re-
cording at any time by pressing STOP (or by 
pressing the Space bar on your computer key-
board). 

To cancel out of a recording and discard the 
current take:

■

Press SHIFT/ADD+STOP.

Record Safe Mode

Pro Tools provides a Record Safe mode to keep a 
track in a session from being record-enabled.

This is a way to avoid inadvertently recording 
over a track, particularly in large sessions where 
some tracks may be outside of the currently vis-
ible bank. 

Record Safe mode also expands the uses for the 
MASTER REC switch. If you protect selected 
tracks with Record Safe mode, then MASTER 
RECORD becomes a one-touch way to record 
enable the remaining tracks.

To enable record safe status on a channel strip:

1  

Press REC SAFE.

2  

Do one of the following:

• Press REC ARM on the channel you would 

like to put into Record Safe mode.

– or –

• While pressing 

(CTL), press the channel 

REC ARM switch.

The REC SAFE LED will light when any tracks are 
placed in Record Safe mode.