BMW 2009 328i xDrive Sports Wagon オーナーマニュアル
225
Access to the bulbs
The high-beam bulb can be accessed from the
engine compartment, whereas the low-beam
bulb can be accessed through a flap in the wheel
well.
engine compartment, whereas the low-beam
bulb can be accessed through a flap in the wheel
well.
1 Cover for high-beam headlamp
2 Cover for low-beam headlamp
3 Turn signal bulb socket
To remove the covers:
2 Cover for low-beam headlamp
3 Turn signal bulb socket
To remove the covers:
1.
Fold the respective wire bracket to the side,
see arrows.
see arrows.
2.
Flip open the cover and take it out of the
guide.
guide.
Follow the same steps in reverse order to reat-
tach the covers.
tach the covers.
Access through the wheel well
Only for low-beam headlamps and turn signals:
1.
Turn the wheel inwards.
2.
Open the flap in the wheel well. To do so,
turn the fastener counterclockwise using a
coin, for example.
turn the fastener counterclockwise using a
coin, for example.
Changing low-beam and high-beam
bulbs
bulbs
1.
Remove the relevant cover for the head-
lamp.
lamp.
2.
Disconnect the plug from the bulb.
3.
Push the wire bracket to the side out of the
mounting, arrow
mounting, arrow
1, and fold it down, arrow 2.
4.
Remove the bulb.
5.
Insert new bulb as shown in the detail of the
illustration above.
illustration above.
6.
Fold up the wire bracket and engage it.
7.
Connect the plug.
8.
Reattach the cover.
Parking lamps, roadside parking lamps
5-watt bulb, W5W
1.
Remove the cover for the high-beam head-
lamp.
lamp.
2.
Pull out the bulb socket, see arrow.
3.
Remove and replace the bulb.
4.
Insert bulb socket.
5.
Reattach the cover.
ba8_E9091_cic.book Seite 225 Mittwoch, 29. Oktober 2008 2:59 14
Online Edition for Part no. 01 41 2 602 099 - © 10/08 BMW AG