Brinly-Hardy Lawn Aerator PA-40 BH ユーザーズマニュアル

9a. The final step is to level Tray (6) using

adjustment bolts as shown here and installed in

Step 2. To adjust, loosen Bolts and position Tow

Bars until level.

Adjust This Surface To Level

Adjustment Bolts

To Tractor

After first thirty minutes of use check all fasteners for

tightness.

To avoid damage to spoons, always engage transport wheels

to raise the spoons when crossing concrete or asphalt walks,

drives, or roads.

Use the Aerator only on an established lawn, never on newly

laid sod.

To avoid possible personal injury and/ or equipment never

exceed the recommended operating speed range of 3 to 5

MPH.

Only tow Aerator behind vehicles for which it was designed,

riders and lawn/garden tractors.

Do not stand/ride on Aerator, bodily injury could result.

Always disconnect Aerator from tractor when cleaning or

servicing unit.

Never exceed the Weight Tray capacity.

Do Not attempt to disconnect Aerator from tractor with weight

in Tray.

When backing, carefully back straight to avoid Jack-knifing,

which could result in damage to equipment.

Your Aerator should not be used when lawn conditions

are too wet or too dry. To determine condition, dig a small

amount of your soil (about three inches deep):

If soil appears powdery and brittle- it is too dry. Wait until a

later date, the Tines will not penetrate properly.

If soil appears damp, roll a small amount into a ball in the

palm of your hand- if it forms a ball, then it is too wet. Ideally,

the soil should fall apart when rolled in the palm of your

hand. Wait until a later date for soil to dry. If soil is too wet,

the Tines will not operate effectively and your tractor could

loose traction, causing lawn damage.

Attach aerator to your rider or lawn/garden tractor using Pin

and Hairpin Cotter Supplied.

To Place in Transport Position:

Push REARWARD on Lift Handle (11) towards Transport

•

Lock Pin in Side Plate. Pull Handle OUT and mover over

Lock Pin. Aerator now rests on wheels.

To Place in Operating Position:

Pull OUT on Lift Handle (releasing from Transport

•

Lock Pin) and move FORWARD. Aerator now rests on

Plugging Spoons.