Woodstock W1675 ユーザーズマニュアル
Figure 11. Handwheel mounted to the shaft.
Figure 12. Dust port mounted to planer.
ASSEMBLY
-12-
Handwheel Handle
To mount the handwheel to the planer do
these steps:
these steps:
1.
If not already done, insert the roll pin into
the shaft protruding from the front of the
planer. See
the shaft protruding from the front of the
planer. See
Figure 10.
2.
Slide the handwheel onto the shaft and
align the handwheel with the roll pin.
align the handwheel with the roll pin.
3.
Slide the lock washer on the Allen
®
screw
first and then the flat washer.
4.
Thread the Allen
®
screw into the end of the
shaft to secure the handwheel to the shaft
as shown in
as shown in
Figure 11.
5.
Use the T-handle Allen
®
wrench and tighten
the screw.
Dust Port
To mount the dust port do these steps:
1.
Position the dust port onto the chip
deflector at back of the planer.
deflector at back of the planer.
2.
Thread and tighten the three Phillips
®
screws.
Figure 12 shows the dust port
correctly installed on the planer.
Figure 10. Insert the roll pin into shaft.
Handwheel
Screws
Dust Port
Roll Pin
Handwheel
Shaft
Allen
®
Screw
and
Washers
Shaft