Woodstock W1675 ユーザーズマニュアル

-16-

Figure 21. Position the magnets and blade taper.

Figure 22. Position the knife on the cutterhead.

Figure 23. Push the cutterhead lock lever.

2.  Turn the knife to expose the unused blade

or replace it if both blades are dull.

Set the magnets on the knife, so the
beveled edge is facing you. See 

Figure 21.

Use the magnets to lower and seat the knife
onto the cutterhead, and make sure the
guides fit into the holes and the knife sits
flat on the cutterhead. See 

Figure 22.

Use the magnets to lower and seat the knife
binder onto the knife.

Use the T-handle Allen

®

wrench and thread

all six screws into the the cutterhead until
they just contact the knife binder. DO NOT
tighten the screws yet. 

Use the T-handle Allen

®

wrench and  lightly

tighten the screws into place, starting from
the center and alternating back and forth
toward the ends. Repeat this tightening
sequence twice until all are snug. DO NOT
over tighten.

Press the lock lever and rotate the
cutterhead pulley until the cutterhead locks
into position. See 

Figure 23.

Repeat all knife removal and installation
steps on the remaining knife.

10. Make sure all knife binder screws are tight.

11. Reinstall the chip deflector and the dust

port that was previously removed.