Woodstock W1675 ユーザーズマニュアル

-17-

The extension tables have been set at the
factory and require no adjustments upon initial
operation. However, over the life of the planer,
it is possible for the extensions to become
misaligned with the main table and to need
slight adjustment.

Place a good quality, steel straightedge
across both extension table rollers and the
main table. The straightedge should be
perfectly flat across the main table with a
clearance of 0.008" to 0.010" measured with
a feeler gauge, and the straight edge should
evenly touch the rollers on the ends of the
extension tables as shown in 

Figure 24.

If the rollers on the extension tables are not
even or the straight edge does not have the
correct gap with the main table, then the
extensions need to be adjusted.

With the straightedge still in place, use the
adjustment bolts shown in 

Figure 25 to

raise/lower the extension table. 

Back off the adjustment-bolt jam nut (both
sides of the planer) and raise/lower the
extension table so there is no gap at the
table rollers and an 0.008" to 0.010" gap at
the main table under the straight edge.

Snug the adjustment bolts and double-check
your setting. If the alignment is correct,
then hold each bolt in position, and
completely tighten the jam nut.

Repeat steps 1 through 6 for the other
extension table roller.

Figure 24. Check extension tables with a

straightedge. The rollers on the ends of the

tables should be even with the main table.

Figure 25. One of four extension table

adjustment bolts.

"

"